In this Solaris release, the ipmpstat command is the preferred tool to use to obtain information about IPMP group . An alternative method to create an IPMP group is implicit creation, in which you use the syntax ifconfig interface . Page The IPMP group can be configured with active-active interfaces or active-standby interfaces. IPMP In Solaris 11, you need to use “ipadm” command to configure the IPMP. [email protected]:~# ipadm create-ipmp ipmp0. Oracle made a tone of changes to its networking stack in Solaris Persistent network Create the interfaces net1 and net2 to be used in the IPMP group.

SOLARIS: IPMP basics/configuring an IPMP group on Solaris 11 active and standby interfaces when the group was created. IPMP failure. In this Solaris release, the ipmpstat command is the preferred tool to use to obtain information about IPMP group . An alternative method to create an IPMP group is implicit creation, in which you use the syntax ifconfig interface . Page Configuring Wireless Interface Communications on Oracle Solaris · Administering How to Manually Configure an Active-Standby IPMP Group . You can create an IPMP interface even if underlying IP interfaces do not yet exist. The Oracle Solaris 11 IP Multipathing (IPMP) feature has a new conceptual model. Step Create an IPMP interface (group) ipadm create-ipmp ipmp0. Oracle made a tone of changes to its networking stack in Solaris Persistent network Create the interfaces net1 and net2 to be used in the IPMP group. How to configure IPMP in Solaris 11 – Active-Active & Active-Standby. By admin You first create the IPMP group (ipmp0 in this example), and then you add the. Solaris 11 uses 2 methods for probe-based failure detection 1. Firstly create the IPMP group ipmp0: Create the 2 interfaces to be added to the IPMP group: . How to Manually Configure an Active-Standby IPMP Group . You can create an IPMP interface even if underlying IP interfaces have not yet been created. The following procedure describes how to configure an IPMP group in which one Administering TCP/IP Networks, IPMP, and IP Tunnels in Oracle® Solaris . The following example shows how to create an active-standby IPMP. The IPMP group can be configured with active-active interfaces or active-standby interfaces. IPMP In Solaris 11, you need to use “ipadm” command to configure the IPMP. [email protected]:~# ipadm create-ipmp ipmp0.